New 1pcs G1/4〞SFC200 Air filter Two part oil water separator Copper filter

Description

The installation according to the direction indicated by the arrow on the valve body of the piping installation, the direction is the direction of gas flow
Gas source processor products all for the entire copper filter, full brass movement, the whole copper water components, high pressure resistant molecular materials, to bear the pressure of 12 kg
The gas source purifying treatment device is composed of a pressure reducing valve, a filter and an oil mist device. Installation must pay attention to the direction of the gas flow direction of the arrow on the component, do not answer. The installation position of the vertical direction is not more than 5 degrees
The regulating hand wheel of the pressure reducing valve can be locked, so the regulating valve should be pulled out, and then the hand wheel is rotated, and the pressure is increased, and the pressure is reduced. After setting the pressure should be adjusted to lock the hand wheel, pressure relief valve inlet pressure must be greater than the outlet pressure, the maximum inlet pressure of 1.2MPa
Oil mist must be used in line with the ISOVG32 (temperature of 40 C, the viscosity of the oil is 32mm/s) or sewing oil
The amount of oil that can be adjusted by adjusting the amount of oil drop, is normally set at 0.2-1 drops / minute or 0.5-5 drops /1000 liters of air. Please note that the system must not be excessive lubrication! Determine the oil dripping from the right setting, following simple oil fog test ": holding a page white paper the farthest distance cylinder control valve outlet (without silencer) about 10cm, after a period of time. The white paper shows yellow, above the oil drop can be determined whether the excessive lubrication. Another method to judge the excessive lubrication is: Observation of the color of exhaust silencer and status, bright yellow and oil drops that oil mist set too high.
Item Description:
Filter pressure relief valve: SFR-200
Oil mist device: SL-200
Pressure regulating valve: pneumatic system is used to pressure relief and the backlog of pressure control components. It uses air inlet throttle pressure, balance and overflow pressure. To change the gas pressure, first pull out the hand wheel, and then through the mediation of plastic hand wheel to get any pressure within the specified range. Increase the pressure clockwise and reduce the pressure.
Maximum input pressure: 1MPa
Voltage regulating range: 0.05 - 0.85MPa
Ambient medium temperature:5—60℃
package:1pcs
eBay Cross Border Trade powered by ChannelEffect