Dental Lab Equipment JT-19C Dental Wet Model Trimmer With Abrasive Diamond Wheel

Description

Minor scrapes to bottom edges. Pics included
Description
Attention:
If there is some abnormal noise when working on
Possible reason：① Axon is loosing ② Disc is not plain enough.
How to solve it：①Dissemble the disc⒃ with spanner，make the snap
Ring tightly；② change the disc.
The machine does not work when power on
Possible reason：① fuse get burnt；② motor get burnt；③ switch get wrong.
How to solve it：① change the fuse（22） which inside the socket；② change the motor；③ change the switch.
Specification:
1. Voltage: 220V/50Hz±10% ; 110V/60Hz±10%
2. Power: 500W
3. Rotational Speed: 2800 rpm
4. Dimensions: 44×35×35cm
5. Weight of the dental trimmer: 20kg
Content:
1x JT-19C Wet Model Trimmer
Features & details
Connect one end of the water tube to the nozzle of the wet model trimmer and the other end to the tap, open the valve
Connect the waste-disposal tube to the unit
Connect the power cord, and switch on the power switch (O=off, l=on)
When braking, it is normal to hear clicking before the sand tablet stops. If the sand tablet makes unusually loud noises, remove it, and use the included hex-wrench to adjust the screw on the back cover (18)
To check if you need to replace the abrasive disk, rotate the disk by hand and estimate: if the platform jumps more than 2mm, change the disk. After replacing the disk, make sure to tighten the ring on the platform 8 (closest to the outside of the sand tablet)